Wall panels have long been used for decorative purposes, but they are also an attractive solution in other areas.
~ 1 m² with 580 ml foil bag
~ 6 m² with 5 kg plastic pail
One plastic pail is sufficient for bonding a standard shower unit with 2 wall panels.
*Calculation basis spatula-trowel-B3
OTTOCOLL® M 595 can either be taken from the 5 kg plastic pail or the aluminium foil bag and applied directly to the wall or panels. We explain the various application options in our detailed application instructions. Guaranteed success.
In our video, we show you step by step how to quickly and easily bond wall panels to old bathroom tiles with OTTOCOLL® M 595.
By loading the video, you accept the Data Protection Declaration of YouTube.
Attach wall panels to the wall in 5 simple steps.
For successful adhesion of OTTOCOLL® M 595, the wall surface must be stable free of grease and dust. In the case of absorbent substrates such as aerated concrete, the load bearing capacity can be improved with OTTOFLEX® Deep Primer. In sanitary areas it is possible to apply directly onto the OTTOFLEX® Protective coating. Optimum adhesion is achieved by cleaning with OTTO Cleaner T.
After opening the container, remove the packet of silica beads and then, starting at the container edge, pull off the film and remove any hardened material if necessary (do not stir in!). If the adhesive is not needed in its entirety, save the silica bead packet and the film for resealing later.
There are two ways to apply OTTOCOLL® M 595:
The adhesive can be applied with a spatula trowel or directly with a toothed spatula notched trowel.
Tip: A toothed spatula notched trowel size B7 or B12 is recommended for uneven walls.
Before attaching the wall cladding panel, the adhesive must first be moistened. This step is not required if a slightly moist, absorbent (but touch-dry) substrate is being used. If the wall cladding panel is to bonded at a specific distance from the floor, load-bearing supports (e.g. wooden wedges) are required. Set the wall cladding panel down on the floor or substructure material and press, working from the bottom to the top. Load-bearing supports can be removed after approx. 30 minutes, but further loads should be avoided until 48 hours after bonding. To ensure the adhesive fully cures and the reaction product evaporates, exterior sealing of the top side of the wall panel is only recommended after 7 days. The bottom and side joints can be filled once the load-bearing supports transfer has been removed.
To reuse OTTOCOLL® M 595, the container must be sealed airtight:
1. Pour the adhesive in the centre
2. Remove any hardened material
3. Apply film and press air pockets flat
4. Insert the silica beads and close the container
As OTTOCOLL® M 595 is suitable for a wide range of applications, all relevant product properties should be tested in advance and verified in practice. The information in the current technical data sheet must also be observed.
For OTTOCOLL® M 595 in the aluminium foil bag, use either a hand-operated or accumulator gun suitable for foil bags.
This is how it works:
1. Open the aluminium foil bag
2. Place the bag nozzle on top
3. Insert the aluminium foil bag into the gun
Alternatively, the desired amount of adhesive can be spread directly from the aluminium foil bag using a spatula or similar. Further processing is then carried out using a toothed spatula.
 |
Note: We recommend a toothed spatula B3. |
In our product flyer on information OTTOCOLL® M 595 you will find all important information clearly summarised. Browse online or download it.
Our application consultation is available Monday to Thursday from 7:00 a.m. to 4:00 p.m. and Friday from 7:00 a.m. to 1:00 p.m. and will be happy to receive your request.
